KitchenAid W10187117B Instructions D'installation Et Guide D'utilisation Et D'entretien page 12

6. Install blower motor and mounting bracket assembly to the
bracket just below the downdraft tower motor. The blower
exhaust opening should fit through the hole in the large cover
plate on the opposite side of the vent chamber where the
small cover plate was removed. Replace the 2 blower motor
mounting bracket screws and tighten.
B
A. Downdraft tower motor
B. Large cover plate
C. Blower exhaust opening
7. Plug in the wire connector to the blower motor.
A
B
A. Blower motor
B. Wire connector
8. Place the vent extension for the 6" diameter venting over the
vent exhaust and screw into place using the 4 screws.
A
A
A. Vent extension screws (4)
12
A
C
9. Replace the vent box over the blower motor.
A. Blower motor
B. Vent box
10. Place the bottom tab of the blower box into the bottom
mounting channel.
A. Blower box
B. Bottom mounting channel
11. Tilt blower box top tab so it is flush with the vent box panel
and position it under the top mounting bracket.
12. Slide bracket into the "Z" slots.
13. Tighten the 2 hex/slotted head screws to secure.
14. Place the small vent cover over the hole in the vent box and
secure in place with the 4 screws.
B
A
B
A