Normes De Sécurité - Pebaro 0211 Mode D'emploi

3. Place the stones with the neat side to the top. Pick up the stone into the picker with a light
pressure holding the iron upright. (Picture 1).
The crystal stone fits in the hollow of the picker.
4. After a few seconds the glue layer melts and becomes glassy, ready to stick. The larger
the stone, the longer it takes to be ready.
5. Put the setting iron tip with the picker on the material to be decorated. Press it shortly
taking care not to slip and then remove quickly the iron (Picture 2).
Make a few tries in order to use the iron with ease.
6. The crystal stone is now glued and resists washing up to 30° (avoid machine wash).
7. If the stone either falls out of the picker or sticks in it, you'll have to cautiously adjust the
picker with a screw-driver or pliers until the proper size is reached.
For stones not fitting the pickers with hollows proceed as follows: heat one of the 2
pickers without hollow, place the stone on the material to be decorated and press
on it, upright, the warm iron. Wait a few seconds until the glue has melted and the
stone is fixed.
This way you can use larger stones or ones with different shapes (square, oval,
heart-shaped, etc.). Make a few tests first.
Decorating with studs
Heat one of the 2 pickers without hollow, place the stud on the material to be
decorated and press the warm iron on it, upright. Wait a few seconds until the glue has
melted and the stud is fixed.
Please note: small stud = small picker without hollow; bigger stud = use the bigger
picker without hollow.
• L'applicateur ne doit pas être chauffé sans embout.
• Ne pas toucher les embouts chauds avec les mains. Risque
de brûlure ! Lorsque vous travaillez, utilisez un outil pour
changer d'embout et mettez ces derniers à refroidir dans un
bol qui résiste à la chaleur.
NORMES DE SÉCURITÉ:
9