Start The Icemaker - GE 162D7734P009 Manuel D'utilisation

Installing the water line.
Read these instructions completely and carefully.
Connect the Tubing to the Refrigerator
Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
We recommend installing a water filter if your water
supply has sand or particles that could clog the
screen of the refrigerator's water valve. Install it in
the water line near the refrigerator.
Remove the plastic flexible cap from the water
1
valve (refrigerator connection).
Place the compression nut and ferrule (sleeve)
2
onto the end of the tubing as shown.
Insert the end of the copper tubing into
3
the water valve refrigerator connection as far
as possible. While holding the tubing, tighten
the fitting.
Fasten the copper tubing into the clamp
4
provided to hold it in position. You may
need to pry open the clamp.
Turn the Water On at the Shutoff Valve
Tighten any connections that leak.
1
Plug In the Refrigerator
Arrange the coil of copper tubing so that it does not
vibrate against the back of the refrigerator or against
the wall.

Start the Icemaker

Set the icemaker feeler arm to the ON (down)
position. The icemaker will not begin to operate
until it reaches its operating temperature of 15°F
(-9°C) or below. It will then begin operation
automatically if the icemaker feeler arm is in the
ON (down) position.
20
One of the illustrations below will look like the connection
on your refrigerator.
1/4" Copper
Tubing
Remove screws
and fold back
access cover.
Tubing Clamp 1/4" Compression Nut
1/4" Copper
Tubing
Replace the access cover and screws (on some
2
models).
Push the refrigerator back to the wall.
NOTE: The icemaker may double-cycle when it first starts,
causing some water spillage from the icemaker into the
ice bucket. This is normal and should not happen again.
Tubing Clamp
OR
1/4"
Compression
Nut
Ferrule
(sleeve)
Refrigerator
Connection
Ferrule (sleeve)
Refrigerator
Connection