Kenwood DPX792BH Mode D'emploi page 37

Installing the unit (in-dash mounting)
Do the required wiring.
( 34)
Dashboard of your car
Installing in Toyota cars
(except for
Install onto the car brackets using screws (F) or (G) (supplied/ commercially available). Use the mounting holes
( ) or ( ) that fit the car brackets. Then, install the supplied trim plate (C).
Do the required wiring.
( 34)
Dashboard of your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
)
Car bracket
When installing without the mounting sleeve
1 Remove the mounting sleeve and trim plate
from the unit.
2
Align the holes in the unit (on both sides)
with the vehicle mounting bracket and secure
the unit with screws (supplied/ commercially
available).
How to remove the unit
Insert the extraction keys deeply into the slots on
each side, then follow the arrows as shown below.
Use only the specified screws.
Using wrong screws might damage
the unit.
33
ENGLISH