Kenwood DPX792BH Mode D'emploi page 20

BLUETOOTH®
Connect with a remote device by One-touch
(NFC) (for /
Near Field Communication (NFC) enables short-range
wireless communication between the unit and remote
devices.
By holding an NFC-compatible remote device near to
the N-Mark on the unit, the unit and remote device
proceed to complete pairing and established the
BLUETOOTH connection automatically.
1
Activate the NFC function on the remote device.
Refer to the instruction manual of the remote
device for more information.
2
Hold the remote device near to the N-Mark on the
unit.
The device vibrates when pairing is completed.
• To disconnect, hold the remote device near to the
N-Mark on the unit again.
• This unit only can recognize and connect to one NFC-
compatible device at a time.
16
BLUETOOTH — Mobile phone
)
Receive a call
When there is an incoming call:
• ZONE 2 illuminates in green color and flashes.
• The unit answers the call automatically if [AUTO ANSWER] is set to a selected time. ( 17)
During a call:
• The display illuminates according to the settings made for [DISPLAY] ( 23, 24) and ZONE 2
illuminates in green color.
• If you turn off the unit, the Bluetooth connection is disconnected.
The following operations may differ or not available depending on the connected phone.
To
First incoming call...
Answer a call
Reject a call
End a call
On the faceplate
Press or the volume knob or
one of the number buttons (1 to 6).
Press .
Press .
On the remote control
Press .
Press .
Press .