Whirlpool Maytag W10400978A Instructions D'utilisation page 14

External Control Panel
IMPORTANT (External Control only): The display screen on the
dispenser control panel will turn off automatically and enter
"sleep" mode when the control buttons and dispenser levers
have not been used for 2 minutes or more. While in "sleep"
mode, the first press of a control button will only reactivate the
display screen, without changing any settings. After reactivation,
changes to any settings can then be made. If no changes are
made within 2 minutes, the display will re-enter "sleep" mode.
Touch any control button on the dispenser panel to activate
■
the display screen.
Temperature Control
For your convenience, the temperature control is preset at the
factory. When you first install your refrigerator, make sure the
control is still set to the recommended setting as shown.
Internal Control - Recommended Setting "3 Boxes"
14
External Control - Recommended Setting "3 Snowflakes"
Adjusting the Controls
If you need to adjust the temperature in either the refrigerator or
freezer compartment, use the settings listed in the following chart
as a guide.
Press the TEMP button to display the desired number of
■
snowflakes or boxes from (1 snowflake/box [least cold] to all
5 snowflakes/boxes [coldest]).
NOTE: Except when starting the refrigerator, do not adjust the
control more than one setting at a time. Wait 24 hours between
adjustments for the temperature to stabilize.
CONDITION/REASON:
REFRIGERATOR too warm
FREEZER too warm/too little ice
REFRIGERATOR too cold
FREEZER too cold
Cooling On/Off
Your refrigerator and freezer will not cool when cooling is
turned off. Follow the directions specific to your model.
Internal Control Panel
To turn cooling off, press and hold both the SPEEDCOOL and
■
MOISTURE CONTROL buttons at the same time for
3 seconds. When cooling is off, "Cooling Off" will appear on
the display screen.
To turn cooling back on. Press and hold both the
■
SPEEDCOOL and MOISTURE CONTROL buttons at the same
time for 3 seconds. When cooling is on, "Cooling Off" will
disappear and the previously selected settings will appear on
the display screen.
ADJUSTMENT:
FRIDGE TEMP one
more snowflake/box
FREEZER TEMP one
more snowflake/box
FRIDGE TEMP one less
snowflake/box
FREEZER one less
snowflake/box