Safety Instructions; Correct Use; Setup And Commissioning - Kerbl Heat Box 16278 Mode D'emploi

Operating instruction
EN

1. Safety instructions

Read the following instructions carefully before using the device.
Keep these operating instructions in a safe place.
CAUTION!
Risk of physical injury to people and animals and material damage if used incorrectly!
• ensure that the device is only used by people who have the professional skills required to do so
• keep out of reach of children and frail people
• the thermal container warms up and gets hot
• do not place the thermal container on objects or surfaces that are sensitive to heat
• ensure that no flammable or easily combustible materials are placed near the thermal container
• check the operating voltage specified on the mains plug. Only operate the device with the original Protection Class II,
SELV (protective separation) power pack supplied and the designated mains voltage.
• If technical data on the underside of the thermal container (type plate) and/or mains
plug is or becomes illegible, discontinue use.
• for the safety of humans, animals and property, the device must only be connected to mains sockets that are
fused separately with a residual current circuit breaker (RCCB)
• route all electrical supply cables so that they are protected against biting or gnawing
• do not allow electrical supply cables to come into contact with oil or sharp edges
• do not use the thermal container if parts of the casing, power pack or supply cable are damaged
• do not try to repair a damaged supply cable yourself The supply cable can only be replaced by the manufacturer.
• do not pull the plug out of the socket using the cable and do not carry the thermal container around by its cable
• always remove the mains plug from the socket before moving or cleaning the thermal container
• do not immerse in water
• note the maintenance and cleaning instructions

2. Correct use

The thermal container is used to control the temperature of two-component
adhesive cartridges (fits all common 200 ml cartridges such as Technobase 2CB,
only fits Technobase 2CB dosing pistol item. no. 16284). Any other use shall be
deemed incorrect. In the event of the incorrect use of, tampering with or modifications
to the device, or use of a non-genuine power pack, the manufacturer's warranty and
liabilities shall be deemed invalid.
3. Function
The thermal container contains an electric heating conductor
that evenly warms up the containers for the adhesive cartridges.

4. Setup and commissioning

Proceed as follows:
1. Check the thermal container for damage.
2. Place the thermal container on a flat surface or use the
metal brackets to attach to a hoof stand or bar/tube
3. Connect the mains plug to a 230 volt power outlet.
After a short while, the heat can be felt.
4. Unplug the power pack to turn off the thermal container.
7