Testing The Nailer - Interchange NSR83-21 Manuel D'utilisation

NSR83-21
NSC83-28
NSC83-34
12
OPERATING THE NAILER
(Options for all tool models)

TESTING THE NAILER

1
1
ƒ Disconnect air hose from nailer.
ƒ Remove all nails from nailer.
ƒ ALL SCREWS MUST BE TIGHTENED.
ƒ If any screws are loose, tighten them.
THE SAFETY/PUSH LEVER AND TRIGGER
MUST MOVE SMOOTHLY.
2
ƒ Adjust the air pressure to 70psi.
ƒ Connect the air hose.
ƒ Do not load any nails in the nailer.
2
THE NAILER MUST NOT LEAK.
3
ƒ Remove finger from the trigger and press the safety/
push lever against the wood.
THE NAILER MUST NOT OPERATE.
ƒ Separate the safety/push lever from the wood.
ƒ Next, point the nailer in a safe position, pull the
3
trigger and then hold that position for 5 seconds or
longer.
THE NAILER MUST NOT OPERATE.
ƒ Without touching the trigger, depress the safety/push
lever against the work piece.
ƒ Pull the trigger.
THE NAILER MUST OPERATE IF SET IN
SEQUENTIAL FIRE MODE.
4
4
ƒ Hold the trigger back while separating the safety/
push lever from the wood.
ƒ Remove finger from the trigger.
NAILER OPERATION WILL END (the driver blade
will return to the top).
5
ƒ With the nailer off the work piece, pull the trigger.
5
ƒ Depress the safety/push lever against the work piece.
THE NAILER MUST OPERATE IF SET IN BUMP
FIRE MODE.
Interchange Brands Framing Nailers: Operator's Manual