Testing The Nailer - Interchange NSR83-21SPS Manuel D'utilisation

NSR83-21SPS
14
OPERATINg ThE NAILER

TESTINg ThE NAILER

1
1
ƒ Disconnect air hose from nailer.
2
ƒ Remove all nails from nailer.
ƒ ALL SCREWS MUST BE TIGHTENED.
ƒ If any screws are loose, tighten them.
ThE SAfETY/PUSh LEVER AND TRIggER
MUST MOVE SMOOThLY.
ƒ Adjust the air pressure to 70psi.
ƒ Connect the air hose.
ƒ Do not load any nails in the nailer.
2
ThE NAILER MUST NOT LEAK.
ƒ Remove finger from the trigger and press the
safety/push lever against the wood.
ThE NAILER MUST NOT OPERATE.
ƒ Separate the safety/push lever from the wood.
ƒ Next, point the nailer in a safe position, pull the
3
trigger and then hold that position for 5 seconds
or longer.
ThE NAILER MUST NOT OPERATE.
3
ƒ Without touching the trigger, depress the safety/
push lever against the work piece.
ƒ Pull the trigger.
ThE NAILER MUST OPERATE If SET IN
SEQUENTIAL fIRE MODE.
4
4
ƒ Hold the trigger back while separating the safety/
push lever from the wood.
ƒ Remove finger from the trigger.
NAILER OPERATION WILL END (the driver
blade will return to the top).
5
ƒ With the nailer off the work piece, pull the trigger.
5
ƒ Depress the safety/push lever against the work
piece.
ThE NAILER MUST OPERATE If SET IN
BUMP fIRE MODE.
Interchange Brands Framing Nailers: Operator's Manual