Service And Repairs; Service Parts List - Metabo HPT G 12SE2 Mode D'emploi

Replacing carbon brushes (Fig. 7):
<Disassembly>
(1) Loosen the D4 tapping screw retaining
the tail cover and remove tha tail cover.
(2) Use the auxiliary hexagonal wrench or
small screwdriver to pull up the edge
of the spring that is holding down the
carbon brush. Remove the edge of the
spring toward the outside of the brush
holder.
(3) Remove the end of the pig-tail on the
carbon brush from the terminal section
of brush holder and then remove the
carbon brush from the brush holder.
<Assembly>
(1) Insert the end of the pi-tail of the carbon brush in the terminal section of brush
holder.
(2) Insert the carbon brush in the brush holder.
(3) Use the auxiliary hexagonal wrench or small screwdriver to return the edge of the
spring to the head of the carbon brush.
(4) Mount the tail cover and tighten the D4 tapping screw.

5. Service and repairs

All quality power tools will eventually require servicing or replacement of parts because
of wear from normal use. To assure that only authorized replacement parts will be
used, all service and repairs must be performed by a metabo HPT AUTHORIZED SERVICE
CENTER, ONLY.

6. Service parts list

CAUTION:
Repair, modification and inspection of metabo HPT Power Tools must be carried out by an
metabo HPT Authorized Service Center.
This Parts List will be helpful if presented with the tool to the metabo HPT Authorized
Service Center when requesting repair or other maintenance.
In the operation and maintenance of power tools, the safety regulations and standards
prescribed in each country must be observed.
MODIFICATIONS:
metabo HPT Power Tools are constantly being improved and modified to incorporate the latest
technological advancements.
Accordingly, some parts (i.e. code numbers and/or design) may be changed without prior
notice.
Brush Spring
Carbon
Holder
Brush
Fig. 7
English
15