Conventions Used In This Manual; Precautions For Placement And Use; Beware Of Condensation; Cleaning The Unit - Tascam ML-4D/OUT-E Mode D'emploi

Conventions used in this manual

In this manual, we use the following conventions:
0 When we refer to buttons, connectors and other parts
of this unit and other equipment, we use a bold font like
STATUS
this: indicator.
0 As necessary, additional information is provided under
TIP, NOTE and CAUTION headings.
TIP
These are tips about how to use the unit.
NOTE
These provide additional explanations and describe spe-
cial cases.
ATTENTION
Failure to follow these instructions could result in dam-
age to equipment or lost data, for example.
V CAUTION
Failure to follow these instructions could result in injury.

Precautions for placement and use

0 The operating temperature range of this unit is 0–40 °C.
0 Do not install this unit in the following types of locations.
Doing so could make the sound quality worse or cause
malfunction.
Places with significant vibrations
Next to a window or in another location exposed to
direct sunlight
Near heaters or other extremely hot places
Extremely cold places
Very humid or poorly ventilated places
Very dusty places
0 To enable good heat dissipation, do not place anything
on top of the unit.
0 Do not place this unit on top of a power amplifier or oth-
er device that generates heat.
0 When installing this unit on or under a desk, use the in-
cluded attachment brackets.
0 To mount this unit in a rack, use a TASCAM AKRS1 (sold
separately).

Beware of condensation

Condensation could occur if the unit is moved from a cold
place to a warm place, it is used immediately after a cold
room has been heated or it is otherwise exposed to a sud-
den temperature change.
To prevent this, or if this occurs, let the unit sit for one or two
hours at the new room temperature before using it.

Cleaning the unit

Use a dry soft cloth to wipe the unit clean. Do not wipe with
chemical cleaning cloths, thinner, alcohol or other chemical
agents. Doing so could damage the surface or cause discol-
oration.

Using the TEAC Global Site

You can download updates for this unit from the TEAC Glob-
al Site:
http://teac-global.com/
In the TASCAM Downloads section, select the desired lan-
guage to open the Downloads website page for that lan-
guage.

Product registration

Customers in the USA, please visit the following TASCAM
website to register your TASCAM product online.
https://tascam.com/us/
About TASCAM customer sup-
port service
TASCAM products are supported and warrantied only in
their country/region of purchase.
To receive support after purchase, on the TASCAM Distrib-
utors list page of the TEAC Global Site (http:// teac-global.
com/), search for the local company or representative for
the region where you purchased the product and contact
that organization.
When making inquiries, the address (URL) of the shop or
web shop where it was purchased and the purchase date
are required.
Moreover, the warranty card and proof of purchase might
also be necessary.
TASCAM ML-4D/OUT-E / ML-4D/OUT-X
7