Using Dante Controller; Dante Controller Overview; Audio Routing Settings; Changing Sampling Frequencies And Bit Depths With Dante Controller - Tascam ML-4D/OUT-E Mode D'emploi

Using Dante Controller

Dante Controller overview

This unit uses the Dante Controller application, which is
available at the Audinate website, to connect with other de-
vices that support Dante.
Download the latest version of the Dante Controller appli-
cation and an operation manual from the Audinate website.
Audinate download page
https://www.audinate.com/products/software/dan-
te-controller
Make at least the following settings using a computer that
has Dante Controller installed.
0 Adjust the sampling frequency and bit depth of each
Dante device.
0 Set the audio routing.
NOTE
Settings made using Dante Controller are stored in the
built-in memory of each Dante device.
Unless settings are modified, connections will not change
even if Dante Controller is quit or the computer is discon-
nected from the Dante network.

Audio routing settings

When Dante Controller is launched, the Network View
screen shown below will open.
On this screen, you can set and monitor conditions related
to the Dante network.
Receiving device name
1
This is the name of a receiving device on the Dante net-
work.
Receiving device channels
2
These are the names of the channels of the receiving de-
vice on the Dante network.
12
TASCAM ML-4D/OUT-E / ML-4D/OUT-X
Transmitting device name
3
This is the name of a transmitting device on the Dante
network.
Transmitting device channels
4
These are the names of the channels of the transmitting
device on the Dante network.
Audio routing
5
Route the audio channels of the transmitting and receiv-
ing devices that you want to connect here.
Left-click the intersection of the channels you want to
connect on the matrix to connect them.
NOTE
While pressing the computer keyboard Ctrl key, left-click
the "-" at the intersection of device names to connect all
connectable channels at once.
Changing sampling frequencies and
bit depths with Dante Controller
Double-click a device name on the Network View screen to
open the Device View screen.
On this screen, you can set and monitor conditions related
to devices on the Dante network.
Click the Device Config tab to open the page where you can
change the sampling frequency, bit rate and other settings
of the device selected in 1 shown in the illustration below.
Identify Device
1
If the unit is selected by device name (1), clicking this
SAMPLE RATE
icon will cause all 3
blinking.
Clicking it again will return them to their ordinary status.
This allows the quick identification of the device being
operated when multiple units are being used at the
same time, for example.
Device name
2
This is the name of the device that can have its settings
changed in the current Device View.
indicators to start