Working Advice - Bosch GWS Professional 18V-125 PSC Notice Originale

OBJ_BUCH-3153-001.book Page 28 Tuesday, July 11, 2017 1:50 PM
28 | English
Material Application
Masonry, Cutting
stone
The values specified for speed levels are guide values.
 The rated speed of the accessory must be at least equal
to the maximum speed marked on the power tool. Ac-
Status indications
Battery status indicator (User interface) 29 Meaning/Cause
green
yellow
red
Overload protection indicator (User inter-
face) 33
yellow
red
Power tool status indicator
(User interface) 32
green
yellow
Illuminated red
Flashing red
Flashing blue
Connectivity functions
In conjunction with the Bluetooth® Low Energy Module
GCY 30-4, the following connectivity functions are available
for the power tool:
– Registration and personalisation
– Status check, output of warning messages
– General information and settings
– Management
Read the corresponding operating instructions for informa-
tion about the Bluetooth® Low Energy Module GCY 30-4.

Working Advice

 The power tool with inserted Bluetooth® Low Energy
Module GCY 30-4 is equipped with a radio interface.
Local operating restrictions, e.g. in aircraft or hospi-
tals, must be observed.
 Exercise caution when cutting slots in structural walls;
see Section "Information on Structures".
1 609 92A 3UT | (11.7.17)
Accessory
Diamond cutting disc and cutting guide (cutting
stone is permitted only with a cutting guide)
cessories running faster than their rated speed can break
and fly apart.
Battery charged
Battery almost empty
Battery pack empty
Meaning/Cause
Critical temperature has been
reached (motor, electronics, bat-
tery)
Power tool is overheated and
switches off
Meaning/Cause
Status OK
Critical temperature has been
reached or battery is almost empty
Power tool is overheated or battery
is empty
Kickback shutdown or restart pro-
tection has been triggered
Power tool is connected to a mobile
terminal device or settings are be-
ing transferred
 Clamp the workpiece if it does not remain stationary
due to its own weight.
 Do not strain the machine so heavily that it comes to a
standstill.
 After heavily straining the power tool, continue to run
it at no-load for several minutes to cool down the acces-
sory.
 Do not touch grinding and cutting discs before they
have cooled down. The discs can become very hot while
working.
 Do not use the power tool with a cut-off stand.
If the power tool becomes electrostatically charged, the built-
in electronics will switch the power tool off.
To start the power tool, push the unlocking lever 6 forwards
and then push the on/off switch 5 up.
Speed preselec- GWS 18V-125 PSC
tion level
-1
[min ]
3 9000
Solution
Replace or charge battery soon
Replace or charge battery
Solution
Run the power tool at no load and allow it
to cool down
Allow the power tool to cool down
Solution
–
Run the power tool at no load and allow it
to cool down, or replace or charge the
battery soon
Allow the power tool to cool down, or re-
place or charge the battery
Switch the power tool off and on again
–
Bosch Power Tools