Optional Accessories - DeWalt DWV010 Guide D'utilisation

Masquer les pouces Voir aussi pour DWV010:

Guide d'utilisation (33 pages)

Table Des Matières

Table des Matières

Les langues disponibles

FIG. 9

2. Line up filter threads (T) to vacuum head threads and using

moderate force, turn filter clockwise until tight.

NOTE: Use care to not damage filter material.

3. Place the vacuum head (C) onto the container and secure it by

closing the canister latches (D).

Cleaning

WARNING: Blow dirt and dust out of all air vents with dry air at

least once a week. Wear proper ANSI Z87.1 (CAN/CSA Z94.3) eye

protection and proper NIOSH/OSHA/MSHA respiratory protection

when performing this.

WARNING: Never use solvents or other harsh chemicals for

cleaning the non-metallic parts of the tool. These chemicals may

weaken the plastic materials used in these parts. Use a cloth

dampened only with water and mild soap. Never let any liquid get

inside the motor.

Storage (Fig. 1)

1. Empty the canister, refer to To Empty Canister under

Operation.

2. Clean the vacuum inside and outside.

3. Clean or replace filters, refer to Filters.

4. Store the suction hose and the power cord as shown in the

illustration. Secure hose with the hose strap (K) on the back

of the vacuum. Place the unit in a dry room and secure it from

unauthorized use.

Accessories

WARNING: Since accessories, other than those offered by

WALT, have not been tested with this product, use of such

accessories with this tool could be hazardous. To reduce the risk

of injury, only D

WALT recommended accessories should be used

with this product.

Recommended accessories for use with your tool are available

at extra cost from your local dealer or authorized service center.

If you need assistance in locating any accessory, please contact

WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD

21286, call 1-800-4-D

WALT (1-800-433-9258) or visit our website

www.dewalt.com.