Fcc Radio Frequency Interference Statement - Insignia IS-CM100641 Guide De L'utilisateur

IS-CM100641_Combined.fm Page 11 Friday, April 8, 2005 9:34 AM
IS-CM100641 17-inch Color Monitor
Problem
The Power LED is off.
The image is unstable.
The image is not
centered, is too small,
or is too large.
The picture bounces or
a wave pattern is
present in the picture.
The color looks blotchy.
The picture is blurry.
The edges of the
available area on the
screen are not straight.
Federal Communications Commission radio
frequency interference statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio or TV technician for help.
Caution Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
Solution
1 Verify that the monitor is turned on.
2 Verify that the power cord is correctly
connected to an AC power outlet.
1 Verify that the VGA cable is securely
connected to your computer.
1 Adjust the horizontal and vertical size and
center to get the proper image.
1 Keep any devices that may cause electrical
interference away from your monitor.
2 See the FCC information below.
1 Use the degauss feature once.
1 Adjust the contrast and brightness.
2 Use the degauss feature once.
1 Use the geometry controls (such as
pincushion and trapezoid).
www.insignia-products.com 11