Menu Structure; General Warnings - Dal Zotto EDY EVO Manuel Utilisateur

MENU STRUCTURE

To access the menu, keep key 5 pressed for a few seconds.
SET CLOCK
*
ENABLE CHRONO
3
SET CHRONO
3
LANGUAGE
3
USER
* Where present – certain models.
When "ENABLE CHRONO" is not included in the menu, enabling is done directly in SET CHRONO.

GENERAL WARNINGS

Advice to follow for the rst start-ups of the product:
During the rst hours of operation, there may be some smoke or
odours, but they are due to the normal "thermal break-in" process.
During this process, the duration of which changes depending on
the product, it is recommended to:
Š Ventilate the room well
Š If present, remove any majolica parts from the top of the
product
Š Activate the product at the maximum power and temperature
Š Avoid remaining in the room for a long time
Š Do not touch the surfaces of the product
Notes:
The process is completed after a few heating/cooling cycles.
Do not use for the combustion of elements or substances other than
those indicated in the manual.
DO NOT USE ANY INFLAMMABLE LIQUIDS FOR IGNITION!
DO NOT ALLOW THE BAG OF PELLETS TO COME INTO CONTACT WITH THE BOILING HOT STOVE DURING THE FILLING PHASE!
IN THE EVENT OF CONTINUOUS NO IGNITION, CONTACT AN AUTHORISED TECHNICIAN.
IT IS FORBIDDEN TO USE THE APPLIANCE WITHOUT THE DIVIDER AND/OR
GLASS PROTECTION SEE FIGURE AT THE SITE JEOPARDISES THE SAFETY OF
THE PRODUCT AND LEADS TO THE IMMEDIATE VOIDING OF THE WARRANTY
PERIOD. IN THE CASE OF WEAR OR DETERIORATION REQUEST AFTER SALES
ASSISTANCE FOR REPLACEMENT OF THE PART REPLACEMENT THAT IS NOT
UNDER GUARANTEE AS THE COMPONENT IS SUBJECT TO WEAR .
5
ENABLE CHRONO
5
PROG. 1 - 2
ON/OFF
5
IT, EN, FR, DE, ES,PT
5
2 3
5
EASY SETUP
5
STAND BY
5
RESET
START PROG 1
5
CONFIRM
STOP PROG 1
WITH KEY 1
5
5
START PROG 2
2 3
5
STOP PROG 2
2 3
5
Before turning on the product, it is necessary to perform the
following checks:
Š If it is intended to be connected to a hydraulic system, it must
be complete and fully functional and in compliance with the
instructions given in the product manual and with the relevant
regulations in force.
Š The pellet hopper must be completed loaded
Š The combustion chamber and the burn pot must be clean
Š Make sure that the re holder, the ash pan and the pellet
hopper close hermetically (if present in the hermetic version); they
must be closed and there must be no foreign bodies in the sealing
elements and gaskets.
Š Check that the power cord is properly connected
Š The bipolar switch (if present) must be set to position "1".
ENGLISH
Key 1 to con rm parameter/
programming and exit.
Keys 2 and 3 to set data/parameters.
Keys 4 and 5 to go forward or backward
in the menu.
5
5
2 3
5
2 3
5
MON FRI
2 3
5
2 3
2 3
MON FRI
2 3
DAY
2 3
HOURS
2 3
MINUTES
2 3
DATE
2 3
MONTH
2 3
YEAR
2 3
41