Relamping/Maintenance Instructions - ergoline Ambition 300 Instructions D'utilisation

Relamping / maintenance instructions
It is imperative that you, the owner and/or operator, check all compo-
nents for any signs of wear which may occur through normal use.
Observe the cleaning and maintenance schedule specified in the main-
tenance table on Page 31 to 34.
Only replace UV low-pressure lamps with the original lamp type or with
compatible lamps.
Only replace UV high-pressure lamps with the original lamp type or with
compatible lamps.
Should you require any assistance or need additional information, please
call Global Service Division at 800 445 0624, Monday through Friday
7:00 a.m. - 7:00 p.m. CT.
CAUTION – Damage due to improper maintenance!
Improper maintenance can cause the device to be dam-
aged or to become unusable.
– Always comply with the specified maintenance intervals.
– Follow the cleaning instructions.
– If the maintenance intervals for the UV lamps are exceeded or incom-
patible UV lamps are installed, the share of harmful UVB radiation
may increase. Sunburn and other skin damage may result.
Danger of burns from hot lamps and device parts!
If the tanning device was operated before being switched
off and opened, lamps and housing parts may be hot.
WARNING!
– Before replacing lamps or other spare parts, wait until
lamps and metal parts of the device have cooled down
sufficiently.
Danger of pinching!
When opening and closing the tray, panels and covers, you
can pinch your fingers.
35