Bestron DHB42W Mode D'emploi page 43

3. Connect the wiring coming from the down rod to the terminal block on the mounting plate in the following
way (T):
• Blue wire → N
• Brown and black wires → L
4. Now lift the fan from the "J-hook", place the fan over the two screws
the screws firmly (U).
5. Insert the two screws
6. Secure the down rod as depicted in figure V.
7. Now, place a lamp type E27 (60 Watts max.) in the lamp socket (W).
8. Carefully attach the glass lamp cover using the three screws already screwed into the motor housing (X).
1
The fan has now been installed correctly.
You can now switch the mains power back on.
into the mounting plate and tighten them firmly as well (U).
2
1
W
in the mounting plate and tighten
1
U
V
43
1
2
X
EN