Bestron DHB42W Mode D'emploi page 40

7. Now connect the wires to the terminal block on the mounting plate in the following way (G):
• Blue wire → N
• Brown or black wire → L
• Earth wire (yellow-green) →
MONTAGE - Installing the down rod onto the motor
H
1. Remove the cotter pin and metal pin from the down rod (see figure H).
2. Lead the down rod through the canopy (I).
3. Untighten the two screws on the motor (J).
4. Remove the cable binder from around the wiring and lead the wires through the down rod (K). Make sure
not to damage the wiring in the process.
L
5. Reinstall the metal pin into the down rod (L) en secure it by reinsterting the cottor pin (M).
6. Tighten the two screws on the motor (N).
The down rod has now been installed correctly.
MONTAGE - Installing the fan blade holders onto the fan blades
The fan blades of this ceiling fan can be installed both with the white as the wood-colored side pointed
downwards.
1. Take a fan blade holder and place it onto a fan blade as shown in figure O.
2. Insert a screw with a red ring through the fan blade holder and fan blade.
3. Place a cap nut under the fan blade, then tighten the screw into the cup nut.
I J
M
40
EN
K
N