Bestron DLHB42S Mode D'emploi page 43

3. Connect the wiring coming from the down rod to the terminal block on the mounting plate in the following
way (T):
• Blue wire → N
• Brown and black wires → L
4. Now lift the fan from the "J-hook", place the fan over the two screws
the screws firmly (U).
5. Insert the two screws
6. Secure the down rod as depicted in figure V.
7. Connect the wiring of the light fixture to the wiring of the ceiling fan (W).
8. Attach the light fixture using the three screws that have already been screwed into the motor housing (X).
9. Place the lamps type GU10 (50 Watts max.) in the lamp sockets (Y).
1
The fan has now been installed correctly. You can now switch the mains power back on.
into the mounting plate and tighten them firmly as well (U).
2
1
W
in the mounting plate and tighten
1
U
V
43
1
2
X
EN