ION TOTAL PA PREMIER Guide D'utilisation page 9

Linking Two Speakers
To wirelessly link two Total PA Premier speakers:
1. Power on both speakers using their Power Switches.
2. With no Bluetooth connected, press the Mode button on one Total PA Premier to select
Bluetooth as the audio source, which appears as "bt" in the display. This will be the "secondary"
speaker.
3. Press the Link button on a second Total PA Premier to enter Stereo Link Mode. This will be the
"primary" speaker.
4. Wait up to 1 minute for the speakers to make the connection. Once the two speakers are linked,
press the Mode button on the "primary" speaker to select the desired audio source.
5. To disconnect, double-press the Link button on the "primary" speaker.
To link two Total PA Premier speakers using cables:
1. With the Power Switch on each speaker turned to the off position, connect each speaker to a
power outlet.
2. Plug an XLR cable into the Mix Out located on the rear panel of one Total PA Premier speaker.
This speaker (the primary) is the one to which you will connect audio sources such as a Bluetooth
device, microphone, or USB flash drive.
3. Plug the other end of the XLR cable into the XLR Input on the rear panel of your second Total PA
Premier speaker. This second speaker will receive the audio from any devices connected to the
first speaker (the primary).
4. Power on both speakers using their Power Switches.
5. Connect your audio sources to the first speaker (the primary).
6. Make sure that each speaker's Master Volume control is set to the same position.
7. With one of your audio sources playing, gradually turn up the Aux Input Volume on the second
Total PA Premier speaker until the volume of this speaker matches the volume of the first speaker
(the primary).
9