Tilt Function - QEO FL 155H-G Mode D'emploi

EN

TILT FUNCTION

Powering on the laser the TILT function will be activated automatically. „TILT" is flashing during the
activation procedure. When the activation is completed (after 90 sec approx.) „TILT" is displayed
permanently.
Press button
When the TILT function is active:
If the laser is disturbed, the rotation stopps and the laser beam and „TILT" will flash. The laser will not
re-level automatically.
If required self-levelling procedure can be reactivated with button
This instrument has three TILT status:
Activation
=„TILT" flashes slowly during the activation, the instrument in not yet ready for use
Function active
= TILT" is displayed permanently
TILT alarm
= „TILT" is flashing quickly and the rotation stopps.
VIBRATION-WIND-SECURITY
Press this button to activate the VWS mode. The VWS function automatically activates the TILT function.
This function allows continuous operation during periods of vibration and wind. If a significant movement
occurs the laser stops rotating and the TILT LED starts flashing. Press the VWS button to cancel. Press
the VWS button again to re-activate.
SLEEP FUNCTION (STANDBY) / MAN FUNCTION
Press this button once enter into the SLEEP mode. The instrument and the remote control are now in
standby mode. All values set will be saved. After restart the instrument will work with the same vales as
before.
Note: After 120 min. in standby function the laser automatically powers off.
Press the button again to re-activate the instrument and the remote control.
Press the button long to enter into the MANUAL mode. Now the laser can be used in slope postion as
the instrument does not power off or re-levels automatically.
30
to switch this function on/off.
(VWS FUNCTION)
.