Programming Procedure; Battery Replacement - MZ electronic KOMPASS-8-868 Instructions D'utilisation

Receiver's functioning

Receiver is supplied with 8 relays outputs with common contacts (Please check wiring diagram); common contact must be
connected to positive or negative pole, according to the polarity of the load connected;

In order to avoid overload due to short circuit, put in a 6A fuse.

When you turn on the receiver, the green led LINE blinks few times and after 1 sec. the red led for programming turns on as well.

The red led keeps turned on for about 15 sec., during this time the receiver is enabled to receive a new transmitter's code and to
memorize it. It is possible to store up to 5 transmitters at the same time; whenever more than 5 transmitters are memorized, the
receiver accepts the latest code cancelling the first code received. When the red led is turned off you cannot make any TX
memorizing procedure;

The pressure of one button on the transmitter turns on the corresponding yellow led on the receiver and the operating of the
output that is concerned;

Programming Procedure


After powering the receiver when the red led is turned on steady follow these steps:
1.
2.
3.
4.
5.
6.

In order to add a new transmitter to a device that you already use, turn the receiver on and follow this procedure:

Press and keep pressed the button PROG on the receiver as long as the red led turns on, then release it.

Repeat the procedure starting from step 1

Battery replacement


Unscrew the 6 screws on the transmitter's back and take the rear part of the box away;

Replace the batteries employing exclusively 1.5V AA batteries. Please respect the polarity; reversing batteries doesn't damage
the transmitter, but stops its functioning;

Position the rear cover and screw the closing screws.
Connecting the optional external antenna

Open the receiver and remove the internal antenna from the terminal board;

Cut the cable at the necessary length and keep it as shortest as possible;

Run the cable of the external antenna in the hole already made and connect it to the terminal board: the cable shield must be
connected to the GND contact, and the radio signal wire to the ANT contact:

Close the receiver and fix the antenna to the boat loom by using the flat washer and the nut given in equipment.
KOMPASS-8
Turn the new transmitter on, pressing the button ON;
Keep the button DOWN_LEFT;
Press the button PROGR on the receiver;
Release the button DOWN_LEFT of the transmitter;
If the code has been recognized the led blinks in succession four times, then it turns off in order to confirm that the
new transmitter has been memorized;
Verify the correct functioning of the new transmitter ;
- 5 -
English
Rev. 01– 2017