Options And Accessories - Hatco WFST Série Manuel D'installation & D'utilisation

OPTIONS AND ACCESSORIES

4" (102 mm) Adjustable Legs
The 4" (102 mm) adjustable legs are used to add additional
height to the unit and are available as accessories. Use the
following procedure to install legs.
1. Remove the display rack and secure all glass sides and
doors with tape. Carefully lay the unit on its side. NOTICE:
Do not lay unit on side with control panel.
2. Screw the 4" (102 mm) legs into
the holes in the middle of each
corner bracket. After all the legs
are tightened, return the unit to its
upright position. If the unit is not
level or rocks, turn the adjustable
tip of the appropriate leg to level
the unit.
NOTE: 4" (102 mm) legs are adjustable for leveling the unit.
Use a 5/8" (16 mm) open-end wrench to make leveling
adjustments once the unit is placed in final position.
Self-Closing Sliding Doors
Self-closing sliding doors are available as a factory-installed
options, not for field retrofit.
NOTE: Self-closing sliding doors are available for one side only
on WFST-2X models.
Self-Closing French Doors
Self-closing French doors are available as a factory-installed
option, not for field retrofit.
Shorten
Lengthen
Adjustable Tip
12
Merchandising Decal
Self-adhesive merchandising decals are available to promote
food products. The decals are designed to be installed on three
(3) sides of the cabinet above the glass panels. Merchandising
decals display text reading "Today's Hot Specials" or a graphic
featuring chicken or ribs.
Decal Installation
1. Clean the side panels with a non-oily cleaner, such as
isopropyl alcohol (rubbing alcohol).
2. After the cleaned surfaces have dried, remove the
protective backing from the decal and apply to the panel.
3. Remove any air pockets or bubbles behind the decal by
rubbing gently with a soft cloth from the center towards
the outer edges.
Display Sign Holder
A Display Sign Holder can be installed on the front of the unit.
Use the following procedure to install a Display Sign Holder.
WARNING
ELECTRIC SHOCK HAZARD: Turn the power switch OFF,
unplug the power cord, and allow the unit to cool before
performing any maintenance or cleaning.
NOTE: Signage not supplied by Hatco. Sign dimensions are
31-15/16" W (811 mm) x 6-1/4" H (159 mm).
1. Remove the two front cover screws from the cabinet cover.
2. Align the mounting holes on the sign holder with the holes
on the cabinet cover.
3. Insert the cover screws through the holes in the sign
holder and into the cabinet cover. Tighten securely.
Halogen Bulbs
Optional halogen bulbs (Hatco P/N 02.30.081.00) can be
ordered in place of the standard incandescent display light
bulbs (120 V).
English
Form No. WFSTM-0117