Changing The Dome Light Lamp - Pioneer AVR-W6100 Mode D'emploi

• Be sure to use the included screws to attach this product to the installation
kit.

Changing the Dome Light lamp

If the Dome Light's bulb burns out, it has to be replaced.
CAUTION
• When changing the bulb, be sure the Dome Light switch is set to OFF.
• Before changing the bulb, consult with your nearest dealer, specialist or
Pioneer service facility.
• Change the bulb when the car is stationary and in a safe place.
• A bulb that was lit and its surrounding area are hot, so wait for a sufficient
amount of time before handling to avoid injury.
• Be careful not to break the bulb when removing it.
• When changing the bulb, do not lose the removed screw or other parts.
• Follow local regulations when disposing of the used bulb.
• Correct operation cannot be guaranteed if products other than those speci-
fied are used.
34