Whirlpool W10913647B Guide De L'utilisateur page 12

3. Disconnect the wiring plug located on top of the door hinge.
Grasp each side of the wiring plug. With your left thumb,
■
press down to release the catch and pull the sections of
the plug apart.
NOTE: Do not remove the green ground wire. It should
remain attached to the door hinge.
4. Using the TORX
T25
® ®
screws from the top hinge and set aside.
NOTE:
Provide additional support for the refrigerator door while
the hinges are being removed. Do not depend on the door
gasket magnets to hold the door in place while you are
working.
A
A. TORX ® T25
B. Ground wire (Do not remove.)
12
screwdriver, remove the 2 internal
B
screws
®
5. Lift the refrigerator door from the bottom hinge pin. The top
hinge will come away with the door.
NOTE: It may not be necessary to remove the bottom hinges
and brake feet assemblies to move the refrigerator through a
doorway.
Only if necessary, use a TORX
■
remove the bottom hinges and brake feet screws.
Replace Right-Hand Refrigerator Door
1. Set the right-hand door onto the bottom hinge pin.
2. Insert the top hinge pin into the open hole in the top
of the refrigerator door.
3. Using the 3 TORX T25
®
to the cabinet. Do not tighten the screws completely.
Replace Left-Hand Refrigerator Door
IMPORTANT: Do not intertwine the water tubing and wiring
bundles when reconnecting them.
1. Set the left-hand door onto the bottom hinge pin.
2. Using the 3 TORX T25
®
cabinet. Do not tighten the screws completely.
3. Reconnect the water dispenser tubing.
Insert the tubing firmly into the fitting until it stops. Close the
clasp around the tubing. The clasp snaps into place between
the fitting and the collar. Connect blue female side with blue
male side and clasp. Repeat with gray female and gray male
side.
4. Reconnect the electrical wiring.
Push together the 2 sections of the wiring plug.
■
Final Steps
1. Completely tighten the 6 internal TORX
the right-hand door hinge and 3 on the left-hand door hinge).
2. Replace both top hinge covers.
T25 screwdriver to
® ®
screws, fasten the hinge
screws, fasten the hinge to the
®
T25 screws (3 on
® ®