Electrical Connection; Technical Data; Putting The Appliance Into Operation - FORS TIFS 644 FB Instructions De Montage Et D'utilisation

Instructions for assembly

Electrical connection

• The electrical connection must be carried out by a
qualified electrician who is authorised to carry out such
work!
• Statutory regulations and the connection specifications issued
by the local power supply company must be strictly observed.
• When connecting the appliance it must be ensured that there
is a device which makes it possible to disconnect it from the
mains at all poles with a contact opening width of at least
3mm. Line-protecting switches, fuses or contactors are
suitable cut-out devices.
When connecting and repairing the appliance disconnect it
from the electricity supply with one of these devices.
• The earth wire must be sufficiently long so that if the strain
relief fails, the live wires of the connecting cable are subjected
to tension before the earth wire.
• Any superfluous cable must be removed from the installation
area beneath the appliance.
• Make sure that the local mains voltage is the same as the
voltage on the rating label.
• Full protection against accidental contact must be ensured on
installation.
• Attention: Incorrect connection may result in the power
electronics unit being destroyed.
Power supply
Mains voltage: 380-415V 2N~, 50/60Hz
Component rated voltage: 220-240V
No mains cable present in the factory
• To connect the appliance, unscrew the cover of the connection
socket on the underside of the appliance in order to be able to
access the terminal. After connecting the appliance, replace
the cover and secure the connection cable with the strain relief
clamp.
• The connection cable must be at least H05 RR-F.
Electrical connections: 6-pole connection
Mains cable available in the factory
• The hob has been fitted with a temperature-resistant
connection cable in the factory.
• Connection to the mains is carried out in accordance with the
circuit diagram, unless the connection cable is already fitted
with a plug.
• If the excess cable of this appliance is damaged, it has to be
replaced by the manufacturer, the Customer Service of the
manufacturer or by another qualified person to avoid danger.
36
Electrical connections
* Attention! Special power supply 220 - 240 V 3~ !

Technical data

Hob dimensions
Height/ Width/ Depth. . mm
Cooking zones
front left. . . . . . . . mm/ kW
back left . . . . . . . mm/ kW
back right . . . . . . mm / kW
front right. . . . . . . mm / kW
Hob, total . . . . . . . . . . kW
* Power when the power boost function is activated

Putting the appliance into operation

Once the hob has been installed and the power supply has been
provided (mains connected) an automatic test of the controls will
be carried out and information for Customer Service will be
indicated.
Important! No items may be on the touch control sensor keys
when the appliance is being connected!
Briefly wipe over the surface of the hob with a sponge and soapy
water and then dry with a clean cloth.
GB
50 x 600 x 520
50 x 800 x 520
220 x 190 / 2.1 (3.7)*
220 x 190 / 2.1 (3.7)*
220 x 190 / 2.1 (3.7)*
220 x 190 / 2.1 (3.7)*
7.4