Operation
Suitable for induction cooking
26
Operating the keys
The controls described here expect the pressing of a (selection) key to be
followed by the pressing of a subsequent key.
The next key will need to be pressed within 10 seconds, otherwise the
selection will be deleted.
Switching on the hob and cooking zones
1. Press the ON/OFF key
appears and a short signal will sound.
The symbols
The controls are ready for operation.
2. The touch control
immediately afterwards. A power setting will be switched on.
........ left .......................... power level 0
........ center..................... power level 4
........ right........................ power level 9
See the section on Worth knowing about the slider (touch control).
Press the respective touch control
or to switch on an additional cooking zone.
3. Immediately put cookware suitable for induction cooking onto the
cooking zone. The pan recognition device will activate the induction coil.
The pot or pan will be heated up.
As long as no cooking pot is placed onto the cooking zone, the display
will alternate between the power level set and the symbol
If no pot is placed on the cooking zone it will switch off after 10 minutes
for reasons of safety. Please refer to the Section on pan recognition.
Switching off a cooking zone
4. a) Press the touch control
b) Drag your finger to the left across the touch control
reduce the power setting to 0
c) Press the ON/OFF key
cooking zones are switched off).
Switching off the hob
5. Press the ON/OFF key
irrespective of any settings.
Please note:
The hob will switch off automatically after 10 seconds when all the cooking
zones are switched of manually (power setting 0) and no key/touch control is
pressed afterwards.
(approx. 1 sec.) until the power setting 0
will light up all the time.
of a cooking zone must be activated
to change a power setting
on the far left or
. The entire hob will be switched off (all the
. The hob will be completely switched off,
GB
.
to