Listening To Your System; Using Direct Listening; Using The Balance And Tone Controls; Playing Other Sources - Pioneer A-A6-J Mode D'emploi

04

Listening to your system

Chapter 4:
Listening to your system

Using Direct listening

Use the Direct listening feature when you want
to hear the truest possible reproduction of a
source. All unnecessary signal processing
bypassed, and you're left with the pure sound
source.
• While listening to a source, press DIRECT
to switch Direct listening on or off.
Using the balance and tone
controls
Depending on what you are listening to, you
may want to adjust the bass, treble or left/right
balance using the remote control.
1 Press TONE/BAL to select the option you
want, then use the L/– and R/+ buttons to
adjust as necessary.
• BASS – Adjust the amount of bass from
–10 to +10.
• TRE – Adjust the amount of treble from
–10 to +10.
• BAL – Adjust the amount of left/right
balance as you like. FLAT indicates a
centered balance.
Wait about five seconds for your changes to be
input automatically. The BASS and TREBLE
indicators light in the front panel when the
corresponding tone control is active.
• To return to the flat setting (tone control
off), press L/– and R/+ at the same time.
Note
1 The balance and tone controls are disabled, and the front panel display switches off.
2 The amplifier's volume, balance and tone controls have no effect on the recorded signal.
12
En

Playing other sources

1 Turn on the power of the playback
component.
1
is
2 Turn on the power of the amplifier.
3 Select the source you want to playback.
Use the input select buttons (or INPUT
SELECTOR dial).
4 Start playback of the component you
selected in step 1.

Making an audio recording

You can make an audio recording from any
audio source connected to the amplifier.
1 Select the source you want to record.
Use the input select buttons (INPUT
SELECTOR).
2 Prepare the source you want to record.
Tune to the radio station, load the CD, set up
the turntable, etc.
3 Prepare the recorder.
Insert a blank tape, MD, etc. into the recording
device and set the recording levels.
Refer to the instructions that came with the
recorder if you are unsure how to do this.
4 Start recording, then start playback of the
source component.
2