Before Use - Metabo HPT DN 18DSL Instructions De Sécurité Et Mode D'emploi

English
NOTE
○ Charging times may be longer depending on the
surrounding temperature and battery conditions.
○ Remove the battery from the charger when not in use.

BEFORE USE

Check the work area to make sure that it is clear of debris
and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
OPERATION
1. Mounting and dismounting of the bit.
(1) Mounting the bit.
At fi rst, remove the the battery from the tool.
Loosen the sleeve by turning it toward the left (in the
counterclockwise direction as viewed from the front)
to open the clip on the keyless chuck. After inserting
a driver bit, etc., into the keyless drill chuck, and
tighten the sleeve by turning it toward the right (in the
clockwise direction as viewed from the front). (See
Fig. 6).
Loosen
NOTE
If the sleeve becomes loose during operation, tighten
it further.
The tightening force becomes stronger when the
sleeve is tightened.
(2) Dismounting the bit
At fi rst, remove the the battery from the tool.
Loosen the sleeve by turning it toward the left (in the
counterclockwise direction as viewed from the front),
and then take out the bit etc. (See Fig. 6)
CAUTION
When mounting a bit into the keyless chuck,
tighten fi rmly. If the sleeve is not tight, the bit
may slip or fall out, causing injury.
NOTE
When it is no longer possible to loosen the sleeve,
use a vise or similar instrument to secure the bit. Turn
the sleeve to the loose side (left side) for a moment. It
should be easy now to loosen the sleeve.
12
Sleeve
Tighten
Fig. 6
2. Confi rm that the battery is mounted correctly.
3. Installing the side handle.
Screw the side handle into the gear cover tightly.
(Fig. 7)
Gear cover
4. Check the rotational direction.
The bit rotates clockwise (viewed from the rear side)
by pushing the R-side of the selector button.
The L-side of the selector button is pushed to turn the
bit counterclockwise (See Fig. 8). (The
marks are provided on the body.)
Trigger switch
mark
○ When the trigger switch is depressed, the tool rotates.
When the trigger switch is released, the tool stops.
○ The rotational speed of the drill can be controlled by
varying the amount that the trigger switch is pulled.
Speed is low when the trigger switch is pulled slightly
and increases as the trigger switch is pulled more.
○ When releasing the trigger switch, the brake will be
applied for immediate stopping.
CAUTION
● The motor rotation may be locked to cease while
the unit is used as drill. While operating the angle
drill, take care not to lock the motor.
● If the motor is locked, immediately turn the
power off . If the motor is locked for a while, the
motor or battery may be burnt.
● A buzzing noise is produced when the motor
is about to rotate; This is only a noise, not a
machine failure.
Tighten
Side handle
Loosen
Fig. 7
and
mark
Selector button
Fig. 8