Assembly And Operation - Metabo HPT DN 18DSL Instructions De Sécurité Et Mode D'emploi

English
APPLICATIONS
○ Use as a drill
Drilling of soft steel and wood.
○ Use as a screwdriver
Tightening and loosening of wood screws.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
○ How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 4).
○ How to remove the battery.
Withdraw battery from the tool handle while pressing
the latch (2 pcs) of the battery (Fig. 4).
Battery
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the
nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
10

ASSEMBLY AND OPERATION

Handle
Push
Latch
Pull out
Insert
Fig. 4
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted
into the receptacle, pilot lamp will blink in red. (At
1-second intervals)
WARNING
Do not use the electrical cord
if damaged.
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in
Fig. 5. Make sure it contacts the bottom of the battery
charger.
Pilot lamp
3. Charging
○ When the battery is connected to the battery charger,
charging will commence and the pilot lamp will light in
red. (See Table 2)
NOTE
If the pilot lamp does not light or blink in red, pull out
the plug from the receptacle and check if the battery
is properly mounted.
○ When the battery is fully charged, the pilot lamp
will blink in red slowly. (At 1-second intervals) (See
Table 2)
Have it repaired
Battery
Fig. 5