Safety Information - Steba VT 3 Mode D'emploi

Generally
This appliance is for private use only and must not be used commercially. Please read
the instruction manual carefully and keep it at a safe place. When the appliance is
given to another person the instruction manual should be passed to that person, too.
Only use the appliance as described in the instruction manual and pay attention to
the safety information. No liability for damages or accidents will be accepted, which
are caused by not paying attention to the instruction manual.

Safety information

∙ Connect and operate the appliance only in accordance with the specifications on
the rating plate.
∙ Do not use if the cord or appliance is damaged. Always check before using the
appliance! Only the appropriate connector must be used.
∙ The appliance is to be connected to a socket-outlet having an earthing contact.
∙ This appliance is not intended for use by persons (including children)
with reduced physical, sensory, or mental capacities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety
∙ Children should be supervised to ensure that they do not play with the appliance.
∙ After using the appliance or if the appliance malfunctions, always pull out the plug.
∙ Never pull at the cord set. Do not chafe it over edges or squeeze it.
∙ Keep the power supply cord away from hot parts.
∙ Move switch to „O" when device is not being used
∙ Do not leave the apliance outdoors or in a damp area.
∙ Never immerse the appliance in water.
∙ Do not operate the appliance if it is damaged (for example if it felt down).
∙ The manufacturer is not liable for damage occurred by using the apliance in ano-
ther way than described or if a mistake in operating has been made
∙ To prevent injury, repairs such as replacing a damaged cord, should only be carried
out by customer service.
∙ The appliance is not intended to be operated by means of an external timer or
separate remote control system.
∙ Do not direct the air flow from the device at naked flames (e.g. fireplaces,
candles etc.). Do not cover the intake or the outlet.
Working place:
∙ Place this device on a even and stable surface. Do not place the device
near objects that may be sucked in (such as curtains)
∙ Do not place the device directly in front of people or animals.
∙ For your health's sake, please select the correct air speed.
6
Assembly:
Ensure that device is
disconnected during
assembly.
Attach straight tubes to
bent sections and screw in
place with 4 screws.
Safety instructions when using the device:
∙ Always connect the device to a safety socket
∙ Do not use the device unless it is fully assembled.
∙ Route connecting cable in such a way as to avoid unintentional contact or pulling
during operation.
∙ Unplug device from socket before moving its location.
∙ Disconnect mains plug after use and before cleaning.
Operation:
The device has 3 air speeds „O - 1 - 2 - 3" and can be swivelled by 90°.
Winter: Swivel the exhaust opening so that it is pointing at the ceiling and move the
switch to position „1". This will create circulation, and temperature differences in the
room will be balanced out.
Summer: Swivel the device to a horizontal or slightly angled position and move the
switch to position „2 - 3". Do not position the intake near an outside door - otherwise
cold air may be blown into the room.
Cleaning and maintainance:
∙ Unplug the device.
∙ Never immerse the device in water!
∙ Use a humid cloth with a little bit of detergent to clean it.
∙ Clean dusty ventilation grilles with a vacuum cleaner.
7