Rotating Mechanism (Mab 845 Only); Drilling With The Machine - BDS Maschinen MAB 825 Mode D'emploi

Operation

Rotating mechanism (MAB 845 only)

Drilling with the machine

Drilling with twist drills
54
In order to permit optimum alignment even in difficult positions,
the model MAB 845 is additionally equipped with a rotating
mechanism. It allows the upper part of the machine to be rotated
by 30° to both sides and by 20 mm forwards and backwards with
the magnetic foot engaged.
Loosen the locking device of the rotating mechanism (13).
‹
Position the upper part of the machine laterally and longitu-
‹
dinally.
Lock the rotating mechanism again.
‹
CAUTION
► Operate the machine only with the rotating mechanism
locked.
Proceed as follows when drilling with twist drills:
Push twist drills with MK taper from below into the morse
‹
taper (3) of the machine.
Push twist drills with straight shank into the drill chuck after
‹
fitting the drill chuck.
Position the machine at the working location, align it and
‹
switch on the magnetic clamps.
Select the appropriate speed and switch on the machine.
‹
NOTE
Observe the following instructions when drilling with twist drills:
► Under high pressure, the drill can glow out and the machine
can be overloaded.
► Pay attention to a regular chip discharge. With larger drilling
depths, break the chip.
MAB 825/845