Fda Consumer Update - LG G3 D852G Guide De L'utilisateur

Safety Guidelines

FDA Consumer Update

The U.S. Food and Drug Administration Centre for Devices and Radiological Health
Consumer Update on Mobile Phones.
1. Do wireless phones pose a health hazard?
The available scientific evidence does not show that any health problems are associated
with using wireless phones. There is no proof, however, that wireless phones are
absolutely safe. Wireless phones emit low levels of radio frequency energy (RF) in the
microwave range while being used. They also emit very low levels of RF when in the
standby mode. Whereas high levels of RF can produce health effects (by heating tissue),
exposure to low level RF that does not produce heating effects causes no known
adverse health effects. Many studies of low level RF exposures have not found any
biological effects. Some studies have suggested that some biological effects may occur,
but such findings have not been confirmed by additional research. In some cases, other
researchers have had difficulty in reproducing those studies, or in determining the
reasons for inconsistent results.
2. What is the FDA's role concerning the safety of wireless phones?
Under the law, the FDA does not review the safety of radiation emitting consumer
products such as wireless phones before they can be sold, as it does with new drugs
or medical devices. However, the agency has authority to take action if wireless phones
are shown to emit radio frequency energy (RF) at a level that is hazardous to the user.
In such a case, the FDA could require the manufacturers of wireless phones to notify
users of the health hazard and to repair, replace, or recall the phones so that the hazard
no longer exists.
Although the existing scientific data do not justify FDA regulatory actions, the FDA has
urged the wireless phone industry to take a number of steps, including the following:
Support needed research into possible biological effects of RF of the type emitted by
•
wireless phones;
Design wireless phones in a way that minimizes any RF exposure to the user that is
•
not necessary for device function; and
18