How To Install; Step 1: Where To Install - SELFSAT H35D Série Manuel D'utilisation

How to Install?

By following the instructions step by step, you can proceed easily to install
SELFSAT-H35D by yourself or with the help of a professional antenna installer.
Before installing your antenna, you check that SELFSAT-H35D box contains all the items listed above in the
'Box Content'. In the event of any missing parts, please contact your distributor.

Step 1: Where to Install?

In order to receive a signal from the Satellite, SELFSAT-H35D is to be installed in an open loop space (outside
the house or the apartment), in the direction of the satellite towards the equator, for which, you will need a
compass to exactly orient SELFSAT-H35D toward the satellite.
Note
please take reference to the table of the Azimuth angles specified in the back pages of this manual.
< Compass >
Note
To ensure an accurate compass reading, stay away from large metal objects, specifically electrical cables
and then make multiple readings.
Make sure that there are no obstacles in front of SELFSAT-H35D which can decrease the signal reception
quality, such as buildings or trees (you may keep in mind that trees will grow and may block the signal).
In order to be able to fix and install your antenna easily, you might choose an easily accessible place without
any potential danger for installation.
Think about the way you might pass your cable in a discreet way from the SELFSAT-H35D to your Set top Box.
The antenna should not be too distant from your satellite receiver; a cable longer than 30 meters may
decrease the quality of the signal.
Bad Quality Singnal Reception
4
< Azimuth Angle >
Good Quality Singnal Reception
BAD! BAD!
o
N 0
Satellite position
Azimuth
Angle
o
S 180
GOOD! GOOD!