VINCENT SV-237 Manuel D'utilisation page 34

CONNECTIONS FOR THE STANDBY CONTROL
ces near the speakers. To employ these functions, direct or indirect cable connections must be made bet-
ween the preamplifier (or integrated amplifier) and all the devices which support this function. The
"POWER CONTROL" function operates in such a way that each switching on or off of one device in the
system (usually the preamplifier) automatically brings about the switching on or off of all the connected
devices which support this function. Please keep in mind that all devices which respond to the power con-
trol are not disconnected from the mains network when switched off. They are set to a standby state inste-
ad. For connecting cables, two-core cables with 3.5 mm jack plugs (mono) are used. For each connecti-
on between two devices one of those cables is needed.
If you don't wish to use this function or if the other components do not support it, all you have to do is
leave out these cable connections.
The SV-237 is equipped with two output connectors for the power control. Here, the switching signal gene-
rated by the amplifier is available for other components of the system. Two HiFi components that are able
to react to the power control signal can be connected directly to the amplifier's power control outputs (16).
If more than two devices, which can be controlled, are to be connected, then it is necessary to make the
power control connection between the amplifier and these further devices through the outputs of the two
devices which are connected directly. For that reason, every HiFi component that accepts power control
signals is also equipped with a power control output. Thus, in theory it is possible to provide an infinite
number of HiFi components with the power control signal. This approach, to loop a signal through a chain
of components, is commonly referred to as "daisy chaining".
SV-237
Many devices which can be controlled by a switching signal (not preamplifiers or integrated ampli-
fiers), have two terminals which do not differentiate between input and output. In this case either of
the two can be selected.
"POWER CONTROL" sockets of preamplifiers or integrated amplifiers must not be interconnected!
All receiving devices must not be connected to more than one preamplifier or integrated amplifier
(directly or indirectly)!
Vincent
34
(POWER CONTROL)
power control cable
e.g. CD player
e.g. main amplifier