Whispbar K671W Instructions De Montage page 10

EN
Fitting Kit
K671W
Remove sealant as shown.
Apply protective strip as shown.
Trim if required.
Assemble as shown.
A = 8mm bolt
B = Spring washer
C = Flat washer
D = Rubber seal
E = Protective strip
Place rubber seal over bolt thread as
shown.
Place the clamps into position as pictured
at the 4 points, ensure the clamp is
orientated the right way in the vehicle
channel.
Using 5mm hex key supplied with this kit,
fully tighten the M8 dome head bolt and
washer supplied to 5Nm (3.7 ft lb) hand
tight.
10