Edit Program - Futurelight PHW-750E Mode D'emploi

Edit program

Select program for auto program
With this function, you can select the program for the Program Run.
Edit program
With this function, you can edit the internal programs.
Edit scenes
With this function, you can edit the scenes of the internal programs.
Rec. Controller
The device features an integrated DMX-recorder by which you can transmit the programmed scenes from
your DMX-controller to the device. Adjust the desired scene numbers by pressing Up or Down (from – to).
When you call up the scenes at your controller, they will automatically be transmitted to the device.
Excursion:
A Master unit can send up to 3 different data groups to the Slave units, i.e. a Master unit can start 3 different
Slave units, which run 3 different programs. The Master unit sends the 3 program parts in a continuous loop.
The Slave unit receives data from the Master unit according to the group which the Slave unit was assigned
to. If e.g. a Slave unit is set to „Slave 1" in the menu „Set to Slave", the Master unit sends „Auto Program
Part 1" to the Slave unit. If set to „Slave 2", the Slave unit receives „Auto Program Part 2".
To start a Auto Program please proceed as follows:
1.Slave-Setting
• Select "Function Mode" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Set to slave" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select "Slave 1", "Slave 2" or "Slave 3".
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
2. Automatic Program Run
• Select "Function Mode" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Auto Program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select "Master" or "Alone". The selection "Alone" means Stand Alone-mode and
"Master" that the device is defined as master.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
3. Program selection for Auto Pro Part
• Select "Edit program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Select programs" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select "Auto Pro Part 1", "Auto Pro Part 2" or "Auto Pro Part 3", and thus select
which Slave program is to be sent. Selection „Part 1" means, that the Slave unit runs the same program as
the master units.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
53/110 00031483.DOC, Version 1.0