SEVERIN KGK 890 Mode D'emploi page 26

7. Disconnect the door bushing from the top
of the freezer door and the hinge shroud
from the bottom of the freezer door.
Replace each on the other side and
tighten the hinge shroud.
(Lower part of the freezer door)
8. Remove the adjustable feet of the
appliance. Loosen the screws on the
lower hinge and remove it.
9. Loosen the screw on the left side of the
appliance and replace it on the other side.
10. Loosen the screw on the lower hinge and
replace it on the other side.
Screw the hinge on the left side of the
appliance. Attach the feet back again.
Place the freezer door onto the lower
hinge.
11. Place the middle hinge onto the hinge pin
of the freezer door and screw the hinge
onto the appliance tight.
12. Remove the hinge shroud from the lower
part of the refrigerator door. Depending on
the model, insert the separately enclosed
or the freshly removed hinge shroud onto
the other side of the refrigerator door and
screw it tight.
13. Remove the hinge cover from the upper
right inside of the refrigerator door and fix
it onto the left side.
14. Place the refrigerator door onto the middle
hinge and place the hinge pin of the top
hinge onto the refrigerator door. Attach
the hinge tight onto the appliance.
15. Replace the lid of the appliance, screw it
tight and replace the screw covers.
16. Finally, check the correct alignment of the
doors. Make sure they are tightly sealed
on all sides. If necessary, align the front
feet of the appliance, so they are in a
horizontal position.
If the appliance has been tilted more than
30°, please wait 4 hours before connect-
ing it to the mains.
- 26 -