Bubbles; Maintenance - XciteRC Flybar 180S Coax Mode D'emploi

Bubbles · Maintenance
WARNING: the motor of the XciteRC FLYBAR 180S may get very hot during operation. Allow to cool
down minimum 20 minutes before the next start to avoid damage. Fire hazard!

Bubbles

Fill the enclosed pipette with bubble fl uid. Place the thin tip into the fi lling hole of the tank (see fi gure) and fi ll
the tank to the upper edge.
Press the „bubble" button on the transmitter during the fl ight. As long as you keep the button pressed, bub-
bles are now being produced.

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fi re hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fi re hazard!
XciteRC Flybar 180S Coax
EN
19