Replacing Carbon Brushes - Makita LXDG01 Manuel D'instruction

− Battery cartridge replacing signal
− When the remaining battery capacity gets low,
the indicator lamp lights up during operation
signaling that it is time to change the battery.
− Accidental re-start preventive function
− Even if the battery cartridge is inserted on the
tool with the slide switch in the "I (ON)"
position, the tool does not start. At this time,
the lamp flickers slowly and this shows that
the accidental re-start preventive function is at
work.
− To start the tool, first slide the slide switch
toward the "O (OFF)" position and then slide it
toward the "I (ON)" position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing wheel point
1
2
3
4
011468
Loosen the collet nut and insert the wheel point into the
collet nut. Use one wrench to hold the spindle and the
other one to tighten the collet nut securely.
The wheel point should not be mounted more than 8 mm
(5/16") from the collet nut. Exceeding this distance could
cause vibration or a broken shaft.
To remove the wheel point, follow the installation
procedure in reverse.
8 mm (5/16") Max.
011469
CAUTION:
A 1/4" collet cone is provided as standard
•
equipment. Use an optional collet cone 1/8" to
install a 1/8" shank wheel point.
1. Wrench 13
2. Wheel point
3. Collet nut
4. Wrench 13
7
OPERATION
011478
Turn the tool on without the wheel point making any
contact with the workpiece and wait until the wheel point
reaches maximum speed. Then apply the wheel point to
the workpiece gently. To obtain a good finish, move the
tool in the leftward direction slowly.
CAUTION:
Apply light pressure on the tool. Excessive
•
pressure on the tool will only cause a poor finish
and overloading of the motor.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
1. Limit mark
1