Accessories - Makita LXDG01 Manuel D'instruction

1
2
011473
Insert the top end of slotted bit screwdriver into the notch
in the tool and remove the holder cap cover by lifting it
up.
1
2
011474
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
Reinstall the holder cap cover on the tool.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Side handle (optional accessory)
011467
1. Holder cap cover
2. Screwdriver
1. Brush holder
cap
2. Screwdriver
or attachments
Only use accessory or
011470
When using
protector, insert the side handle on the tool barrel as far
as it will go and rotate it to the desired angle. Then
tighten the handle firmly by turning clockwise.
CAUTION:
When using the tool without handle, always install
•
the rubber protector on the tool.
When installing the rubber protector, always push it
•
onto the tool so that the top round recessed shape
of the rubber is positioned near the switch
position. .
Wheel points
•
Collet cone (1/4", 1/8")
•
Collet nut
•
Wrench 13
•
Side handle set
•
Various type of Makita genuine batteries and
•
chargers
are
8
the side handle, remove the rubber