Tectro TP 2020 Manuel D'utilisation page 65

I
TROUBLE SHOOTING
Problem Cause
The unit does
No power supply
not function
In direct sunlight
Windows or doors open,
many people or heat source
The unit does
in room
not seem to
Dirty filter
perform
Air inlet or air outlet blocked
Room temperature lower
than selected value
Unit stands uneven
The unit is
The sound is caused by refri-
noisy
gerant circulating inside the
unit
The compressor Overheat protection probably
does not work activated
Distance too great
Remote control
Remote control signal not
does not func-
detected by control panel
tion
Batteries empty
Display shows Room temperature sensor
E0 does not work
Display shows
Reservoir is full
E2
Never try to repair or dismantle the air conditioner yourself. Incompetent repairs
result in loss of warranty and can endanger the user.
Solution
Connect to a functioning out-
let and switch on
Close curtains
Close doors and windows, or
place an extra air conditioner
Clean filter
Remove blockage
Change temperature selec-
tion
Place on even surface (less
vibrations)
This is normal
Wait 3 minutes until the tem-
perature has decreased, and
turn on the unit again
Make sure the remote control
is correctly aimed at the con-
trol panel < 5m
Replace the batteries
Replace the room tempera-
ture sensor (unit also works if
sensor is not replaced)
Empty the reservoir
4
65