Tectro TP 2020 Manuel D'utilisation page 61

COOLING
When the unit is in the cooling mode, the following functions apply:
• The fan speed can be adjusted by pressing the
Maximum setting 
Lowest setting 
• The temperature can be set by pressing the 3
anywhere between 16°C en 31°C. After flashing 4 times the current room
temperature is shown. In automatic mode the unit selects the fan speed
based on the room temperature. The speed cannot be adjusted.
G
It depends on the environment whether the required temperature will
be reached. It is not a malfunction of the air conditioner if the room
temperature remains above the "set temp". It could well be that the
heat load of the room is too much.
DEHUMIDIFYING
The air can also be de-humidified with this device:
1. Select the dehumidifying function
2. Do not connect the de-aeration hose
3. Connect a fixed water drainage hose (not included) and lead the hose to a
water drain. Ensure that the water drainage hose runs downhill for its entire
length.
The air conditioner will now de-humidify as long as the room temperature
is above the set value. The device will be unable to de-humidify if the room
temperature drops below the set value.
AIR CIRCULATION
In this mode the unit only circulates air; the unit will not cool or dehumidify.
The air is filtered.
When the unit is in this mode, the following functions apply:
• The fan speed can be adjusted by pressing the
Maximum setting 
Lowest setting 
When the unit is switched off the most recent setting will be stored in
memory.
The timer function allows you to switch the unit on or off at a certain time.
1. Press TIMER button to set the operating hours you desired and the buttons p
3 and q 4 (1 to 24 hours, the timer indicator will light on). When the set
time has been reached, the machine will turn off automatically. The display
window will show the hour(s) you set as you press TIMER button. If the timer
button is not pressed, the unit will work continuously.
2. By pressing the timer but without turning on the other functions, you can
PRE-SET the time for the machine to work. For example, if you press the timer
to '2', the unit will work automatically after 2 hours.
-button 6
and 4
9 with the mode 5 button
6-button
buttons,
4
61