Hama BASIC L42A Mode D'emploi page 10

g
6. Troubleshooting
Fault
The ready lamp
2
does not
ash or is not
solid green.
Pouches are
not laminated
properly.
NOTE
Contact our customer service department if the problem re-
mains after you have taken the steps detailed above.
10
Possible cause
The on/off switch
3
was not pressed
correctly.
The power cable
is not connected
correctly.
No mains power.
Device is faulty.
The required tem-
perature has not yet
been reached.
Solution
Press the on/off switch
to switch on the device.
Ensure that the plug is
connected to the electri-
cal socket.
Check your fuse box.
Inform our customer
service department.
Wait for the ready light
to become solid green.
Basic L42A
3
2