Installation; Removing The Mp Tray - Kyocera Mita PF-8E Manuel D'utilisation

Installation

Removing the MP Tray

Before installing the bulk paper feeder, remove the MP tray from the
front of the printer. The procedure is as follows.
The printer's MP tray cannot be used together with
the optional bulk feeder.
Pull the printer's paper feed unit release lever, then draw the
1.
paper feed unit fully out of the printer.
Gently tilt the MP tray toward the printer until that it rests on
2.
its side as shown in the figure.
pf8-Eng.pm6
MP Tray
5
Paper Feed Unit
Release Lever
Paper Feed Unit
12/19/00, 8:21 PM
5