Installing The Bulk Paper Feeder - Kyocera Mita PF-8E Manuel D'utilisation

Installing the Bulk Paper Feeder

Mount the bulk paper feeder onto the rail in the lower deck of the base.
The rail is movable and must be pulled out before installing the bulk
paper feeder.
Pull the rail fully out until it stops. See figure below.
1.
Grasp the feeder by the two handles in the side covers.
2.
Facing the paper output slot of the feeder toward the printer,
3.
align the (four) positioning tabs on the rail of the base with the
holes in the base of the feeder. Then slowly and carefully lower
the feeder onto the base.
Printer
Connector
Arrow Marks
8
pf8-Eng.pm6
Rail
Ensure that the arrow marks on the rail are
correctly aligned with the arrow marks on the
front side of the feeder before proceeding.
8
Feeder
PF-8E
Rail
12/19/00, 8:21 PM