Table Des Matières - Kyocera Mita PF-8E Manuel D'utilisation

Radio interference requirement in European countries
The option bulk paper feeder PF-8E is intended for use with the printer models FS-1800,
FS-1800N, FS-3800, and FS-3800N which are type tested and categorized as a Class B
computing devices in accordance with the EN55022 rules.
Device in the Class B category may cause interference to radio or television reception
particularly in a residential installation.
Information to users:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the manufacturer for compliance could void the
user's authority to operate the equipment.
Table of contents
Introduction ............................................................................................ 3
Packing List ..................................................................................... 4
Setup ......................................................................................................... 4
Choosing a Location ........................................................................ 4
Installation .............................................................................................. 5
Removing the MP Tray ................................................................... 5
Installing the Base and the Printer ................................................ 7
Installing the Bulk Paper Feeder ................................................... 8
Operating the Optional Bulk Paper Feeder ................................. 10
Loading Paper ................................................................................ 10
Cleaning Paper Jam ........................................................................... 13
Specifications ....................................................................................... 14
2
pf8-Eng.pm6 2 12/19/00, 8:21 PM