Calira Sealine LG 620-DS/IU Mode D'emploi page 32

&
Connect the charger to the starter battery (battery I) in accordance with the
connection diagram. Pay attention to the cable cross sections and ensure
correct polarity.
* Connect the negative charging cable battery I (blue 10 mm²) to negative
output of the device and the negative pole of the battery I.
* Connect the positive charging cable of the battery I (red 10 mm²) to the
positive output for the battery of the device and the positive pole of the
battery I. It is essential to install a 30 A fuse near the positive pole of the
battery I! Use the provided Maxi-Fuse fuse.
Connect the charger to the D+ contact of the generator in accordance with the
connection diagram.
* Connect the cable (brown 0.75 mm²) to the D+ input of the device and to
the D+ contact of the generator. It is essential to install a 2 A fuse near the
generator! The fuse serves to protect the circuits
* If you are using a charge control panel, connect it to the 7-pole LK-Panel
connection at the device.
* If you are using a temperature sensor for the battery II, stick the
temperature sensor to the face of the battery II (supply battery). To do so,
remove the protective plastic film from the sticking spot of the temperature
sensor and press it firmly to the desired position at battery II (see
description of temperature sensor). Connect the cable of the temperature
sensor to the temperature sensor connection of the device (2-pole
connection).
* When the device is delivered, it is set to operation with liquid electrolyte
batteries. If necessary, set the battery type (liquid or gel) of your battery II
at the changeover switch.
* Connect the mains cable to the power distribution of your boat, mobile
home or caravan.
Connect the green/yellow cable to the earth circuit!
* Check that all the connections are firm and secure.
* Finally make the mains connection with the female device plug of the mains
cable.
32
Lerchenfeldstr. 9 87600 Kaufbeuren Tel.: +49(0)8341 / 9764-0 Fax: +49(0)8341 / 67806
# '
!"#$ % !"#$