Siesta AHQ71CV1 Manuel D'installation page 5

INSTALLATION OF THE INDOOR UNIT (AHQ71/100/125CV1)
Preliminary Site Survey
• Voltage supply fluctuation must not exceed ±10% of rated
voltage. Electricity supply lines must be independent
of welding transformer which can cause high supply
fluctuations.
• Ensure that the location is convenient for wiring, piping
and drainage.
Figure A
Dimension
Model
AHQ71CV1 1320
AHQ100CV1 1538
AHQ125CV1 1786
INSTALLATION DIAGRAM (AHQ71/100/125CV1)
Signal Receiver
Indicator Light
Air Intake Grille
Air Filters
(Inside Air Intake Grille)
H
F
A B C
635 255
635 255
635 255
Air Discharge Louver
Standard Mounting
Ensure that the overhead supports are strong enough to hold
the weight of the unit. Position the hanger rods (wall mounting
bracket for floor standing), and check for its alignment with
the unit as shown in Figure A. Also, check that the hangers
are secured and the base of the fan coil unit is leveled in both
horizontal directions, taking into account the gradient for
drainage flow as recommended in Figure B.
A
E
D E
134 1222
134 1440
134 1688
1-3
Wrap the Insulated pipe with the
finishing tape from bottom to top
TO OUTDOOR UNIT
All dimensions are in mm
F G H
49 148 120
49 148 120
49 148 120